banner
Home » Knowledge » Content
Product Categories

How to debug when the profile wrapping machine is running?

- Jan 04, 2019 -

1. Profile positioning: Take a made profile. Requirement: Can not bend or twist, put it on the bed conveyor wheel, adjust the distance between the two rows of conveyor wheels according to the width, shape and coating requirements of the profile. Adjust the width and height of the ruler and the platform to suit the coating requirements of the profile,install the guide wheels on both sides to make the profile parallel to the direction of movement of the conveyor.


2. Installation and adjustment of the pressure roller: Install and adjust the small pressure roller according to the contour of the profile surface. Generally, select the center line of the profile or the point or low point of the main curve of the profile and contour, and make the point-by-point transition and crushing along the contour of the profile. The profile is laminated to the membrane. Install a small pressure roller to balance the lines and move them at the same time. There is a pressure roller on the top, and the support wheel must be installed at the bottom to balance the lines up and down and left and right. Otherwise, the line joints will be inaccurate. In the large plane, the small pressure roller can be used to gradually roll from the center to the two sides, and the small pressure wheel 3 needs to be gradually rotated at the 90° corner. The lines with complex shapes and small pressure rollers need to be arranged naturally and cannot be forced to form. In particular, the decoration of decorative paper should be natural and smooth.